Skip to content
English
Sign in
www.kiltersystems.com
  • There are no suggestions because the search field is empty.

Using the water tank on the trailer and carrier unit

This article describes how to use the water tank on the trailer and carrier unit for refilling the AX-1 with clean water.

How to pump water from the trailer tank

The trailer and the carrier unit is  equipped with a water tank and a pump for use to refill the AX-1 with clean water.

 

The pump is powered by the generator on the AX-1.

  1. Remove the cap from the power connector of the pump and release the hose connector plug by pressing the release button.
  2. Connect the power cable and the included filling hose to the pump.
  3. Drive the AX-1 close to the trailer and make sure the power generator is running.

  4. Connect the power cable to the generator as shown in the picture below.

    The Generator will power the pump, which will immediately starts running.

  5. You can now fill the tanks of the AX-1.