Starting the Machine
The machine can be started in two ways, depending on whether the generator will be used. If you choose to operate the machine without the generator, the operating time is very limited before the machine runs out of power. Therefore, weed spraying should only be performed with the generator running.
1 - Starting with Generator Operation
Important:
- The generator must be filled with gasoline to start.
- Do not operate the generator with the choke on, as this may cause permanent damage and irregular operation.
Startup Procedure:
- Ensure the power cable to the control unit is connected to the generator. Without this connection, the batteries will not charge.
- Turn the generator switch counterclockwise so that it points diagonally upwards.
- Turn on the choke on the generator.
- Pull firmly on the generator’s starter cord until it starts.
- Turn off the choke.
- Turn the red main switch for the system clockwise so that it is in the "On" position, pointing to the right.
- After approximately 1 minute, the AX-1 can be connected to your mobile or tablet using Kilter Remote. Once the machine is connected to your control device, it is ready for use.
2 - Starting with Battery Operation
The AX-1 can operate solely using its batteries. The generator does not need to be started for this type of operation.
Startup Procedure:
- Turn the main switch clockwise so that it is in the "On" position, pointing to the right.
- Open Kilter Remote and select the machine that was powered on. This will be possible after approximately 1 minute.
- Once the machine is connected to your control device, it is ready for use